H3C S7500 Series Command Manual
Also see for S7500 Series: Operation manualOperation manualOperation manualOperation manualCommand manual
            | |
Command Manual – Link AggregationH3C S7500 Series Ethernet SwitchesChapter 1 Link Aggregation ConfigurationCommands1-8ViewSystem viewParametersinterface-type: Port type.interface-number: Port number.to: Specifies a series of contiguous ports.both: Performs load sharing for both inbound traffic and outbound traffic on all themember ports in the aggregation group.DescriptionUse the link-aggregation command to add a series of ports to a new manualaggregation group, to which the system assigns a group number automatically. Thelink-aggregation group agg-id mode command and the port link-aggregationgroup command can be used together to implement the function of thelink-aggregation command.By default:z For IP packets, the system performs load sharing based on IP addresses;z For non-IP packets, the system performs load sharing based on MAC addresses.Examples# Set up an aggregation group with Ethernet 2/0/1 to Ethernet 2/0/4 and perform loadsharing for both inbound and outbound traffic of the aggregation group. |
Related manuals for H3C S7500 Series
H3C S7500 Series Command Manual
H3C S7500 Series Command Manual
H3C S7500 Series Command Manual
H3C S7500 Series Command Manual
H3C S9500 Series Command Manual
H3C S9500 Series Command Manual
H3C S9500 Series Command Manual
H3C S9500 Series Command Manual
H3C S9500 Series Command Manual
H3C S9500 Series Command Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine