42[DeviceA-Bridge-Aggregation1] port trunk permit vlan 10 20[DeviceA-Bridge-Aggregation1] quit2. Configure Device B in the same way Device A is configured. (Details not shown.)Verifying the configuration# Display detailed information about all aggregation groups on Device A.[DeviceA] display link-aggregation verboseLoadsharing Type: Shar -- Loadsharing, NonS -- Non-LoadsharingPort Status: S -- Selected, U -- Unselected, I -- IndividualFlags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,D -- Synchronization, E -- Collecting, F -- Distributing,G -- Defaulted, H -- ExpiredAggregate Interface: Bridge-Aggregation1Aggregation Mode: StaticLoadsharing Type: SharPort Status Priority Oper-Key--------------------------------------------------------------------------------GE1/0/1 S 32768 1GE1/0/2 S 32768 1GE1/0/3 S 32768 1The output shows that link aggregation group 1 is a Layer 2 static aggregation group that containsthree Selected ports.Layer 2 dynamic aggregation configuration exampleNetwork requirementsOn the network shown in Figure 10, perform the following tasks:• Configure a Layer 2 dynamic aggregation group on both Device A and Device B.• Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the otherend.• Enable VLAN 20 at one end of the aggregate link to communicate with VLAN 20 at the otherend.Figure 10 Network diagram
