Installation ManualH3C S7502 Ethernet Switch Chapter 7 Software Maintenance7-8Checking flash......done!SRPU bootrom update menu:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3Step 11: Type <3> to return to the Boot Menu. Then type <0> to reboot the system andthe system displays the following information:Rebooting...Please change the terminal's baudrate to 9600 bps!Step 12: Change the baud rate of HyperTerminal back to 9600 bps as described inSteps 5 and 6. Then press any key as prompted.Note:You do not need to reset the HyperTerminal’s baud rate and can skip the last step if youhave chosen 9600 bps. In this case, the system does not display the message “Pleasechange the terminal's baudrate to 9600 bps!” as shown in Step 11.III. Loading host softwareFollow these steps to download the host software of the switch:Step 1: Select <1> from Boot Menu. The system displays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3The subsequent steps are the same as those for loading Boot ROM, except for themessages displayed.7.2.3 Loading Software from Ethernet Port Using TFTPI. Introduction to TFTPTrivial File Transfer Protocol (TFTP) is a TCP/IP protocol used for file transmissionbetween clients and servers. It uses UDP to provide unreliable data stream transferservice.
