H3C S9500E Series Command Reference Manual

Also see for S9500E Series: Card Manual Configuration guide Quick start guide Security configuration guide Configuration guide

Contents

H3C S9500E Series Command Reference Manual Manual pdf 21 page image

• When the operating mode of the switch changes from standalone to IRF, the member ID of theswitch is needed for the auto-conversion of the configuration file. If the switch has no member IDconfigured, use the irf member command to set a member ID for it.ely identify and manage members. To set a member ID forthe switch when it operates in standalone mode, use the irf member command, and the memberID takes effect after the operating mode of the switch changes to IRF. To set a member ID the switchber new-member-id command,kes effect after the switch reboot.ber renumber.Examplesh operating in standalone mode to 2.[sysname] irf member 2fect after the switch reboots and operates in IRF modeSyntaxember member-id description text-id descriptionDefault leanage levelParameteof 1 to 127 characters.Descriptidefault, no description is configured for a member switch.rates in IRF mode. If you configure the descriptione operating mode of an IRF member switch toion loses effect even if you switch the operating mode of the switch to IRFription as needed.or IRF member switch 1. system-viewF1Num001• An IRF fabric uses member IDs to uniquwhen it operates in IRF mode, use the irf member member-id renumand the member ID taRelated commands: irf mem# Set the member ID of the switc system-viewInfo: Member ID change will take efirf member descriptionirf mundo irf member memberViewSystem viewvel3: Mrsmember-id: Specifies the ID of an IRF member switch.text: Specifies the description of the member, which is a stringonUse the irf member description command to configure a description for an IRF member switch.Use the undo irf member description command to restore the default.ByThis command is available only when the switch opeof a specified member switch, and then switch thstandalone, this configuratagain. In this case, you need to re-configure the descExamples# Configure a description f[Sysname] irf member 1 description15