Installation ManualH3C S9500 Series Routing Switches Chapter 3 Installing the Switch3-233.9.3 Connecting the AUX CableYou need an AUX cable when configuring the S9500 series with the remotemodem dial-up approach.I. IntroductionThe AUX cable is an 8-core shielded cable. At one end of the cable is anRS-232-compliant RJ-45 connector that can be plugged into the AUX portof the switch. At the other end is DB-9 (male) connector. You can plug itinto the DB-9 (female) port of the modem. The AUX cable is the same asthe console cable. For details, refer to Figure 3-21 and Table 3-3.II. Connecting AUX cable1) Plug the RJ-45 connector of the AUX cable into the AUX port of theswitch.2) Plug the DB-9 (male) connector at the other end into the serial port ofthe modem.3.9.4 Connecting Network CablesI. Introduction to RJ-45 connectorThe 10/100/1000Base-T ports of the S9500 series support MDI/MDI-Xauto-sensing. They are connected to category-5 shielded cables or abovethat are equipped with RJ-45 connectors.Figure 3-23 RJ-45 connectorII. Connection procedure1) Plug one end of the network cable into the Ethernet RJ-45 port to beconnected on the switch.2) Plug the other end of the cable into the RJ-45 port of the peer device.3.9.5 Connecting FiberI. Installing fiber management tray (optional)
