Installation ManualH3C S9500 Series Routing Switches Chapter 5 Troubleshooting and Maintaining the Switch5-14z Loading using TFTP and through Ethernet portz Loading using FTP and through Ethernet port2) Local or remote loading through CLI:z Loading using FTPz Loading using TFTPNote:z When loading Boot ROM and host software, make sure that Boot ROM matches thehost software. You are recommended not to load Boot ROM frequently. You need toload the correct Boot ROM only when the host software to be loaded does notmatch the current Boot ROM.z You can load only Boot ROM and host software of SRPUs through the Boot menu.To load Boot ROM of LPUs, use the CLI mode.5.3.2 Local Loading through Boot MenuCaution:Never hot-plug the CF card after you enter the Boot ROM menu. After replacing the CFcard, you must reboot the SRPU. Otherwise, the CF card cannot work properly.I. Boot menuAfter powering on the Switch, run Boot ROM program first and the terminal will displaythe following information:ZBB_TESTStarting...************************************************** ** H3C S9500 Bootrom, Version 206 ** **************************************************Copyright(c) 2004-2007 Hangzhou H3C Technologies Co., Ltd.CPU type : MPC755CPU L2 Cache : 1024KBCPU Clock Speed : 400MHz
