10SAP-24GBPThe SAP-24GBP has 24 high-performance fiber SFP ports that can be both routed and switched. Onetwo-color LED is available for each port to indicate their activity and link status. The module also has aRUN LED to indicate the module operating status.Figure 14 SAP-24GBP front panel(1) SFP ports 0 to 23 (2) SAP module status LED (RUN)(3) LEDs for SFP ports 0 to 23 (4) Ejector levers(5) Captive screwOAP cardsYou can install an OAP card in a service module slot to provide value-added services such as securityand voice. An OAP card is OAA-enabled and has an independent operating system. You can follow theOAA standard to customize your own OAP cards.For the OAP cards available for the routers and their compatibility, see “Appendix B Hardwarecompatibility matrixes.” For more information about the OAP cards, see the H3C SR6600 RoutersInterface Module Guide.HIMs and MIMsYou can install HIMs to provide 10-Gbps service processing capability and install MIMs to providehigh-density narrowband aggregation. The HIMs and MIMs can offer a variety of interfaces, includingserial, Ethernet, POS, and E1.The H3C SR6604 and SR6608 routers support the mix of HIMs and MIMs.For the HIMs and MIMs available for the routers and their compatibility, see “Appendix B Hardwarecompatibility matrixes.”Power suppliesThe H3C SR6604 and SR6608 routers can be DC-powered or AC-powered. You can install two powersupplies in your router, and they must be the same model.The H3C SR6604 and SR6608 routers use hot swappable power supplies. You can install one powersupply, or for redundancy, two power supplies for your routers.AC-input power supplyThe AC input voltage range is 100 VAC to 240 VAC at 50 Hz to 60 Hz.
