H3C WX Series Configuration Manual

Also see for WX Series: Configuration guide Getting started guide Command reference Command reference Registration and activation guide

Contents

H3C WX Series Configuration Manual Manual pdf 41 page image

41To do… Use the command… RemarksDisplay information aboutthe priority trust mode on aportdisplay qos trust interface[ interface-typeinterface-number ]Available in any viewSupport fort the keywords ofthe command varies by ACmodel. For moreinformation, see QoS in theACL and QoS CommandReference.Priority mapping configuration examples (on WXSeries access controllers)NOTE:The configuration examples were created on a WX5002, which may vary by AC model.Ethernet interface configuration may vary by AC model. For more information, see Table 8 .Table 8 Ethernet interface configuration prerequisitesHardware Ethernet interface configuration prerequisitesSwitchesinstalledwithaccesscontrollermodulesAccesscontrollermodulesLS8M1WCMA0LSQM1WCMB0LSBM1WCM2A0LSRM1WCM2A1No special requirements. You can directlyconfigure Ethernet interfaces on the switch.To configure wireless features during theconfiguration process, log in to the accesscontroller module with the oap connect slotslot-number command.LSWM1WCM10LSWM1WCM20No special requirements. You can directlyconfigure Ethernet interfaces on the switch.To configure wireless features during theconfiguration process, log in to the accesscontroller module with the mcms connect [ slotslot-number ] system system-name command.UnifiedswitchesWX3024WX3010WX3008Use the oap connect slot 0 command on theaccess controller engine to log in to theswitching engine.Accesscontrollers WX6103Use the oap connect slot 0 command on theactive main control board to log in to the switchinterface board.