H3C WX Series Configuration Manual

Also see for WX Series: Configuration guide Getting started guide Command reference Command reference Registration and activation guide

Contents

H3C WX Series Configuration Manual Manual pdf 57 page image

57PQ configuration procedureYou can configure PQ by applying a PQ list to an interface. For an interface, the latestapplied PQ list overwrites the previous one.Follow these steps to configure PQ:To do... Use the command... RemarksEnter system view system-view —Configure a PQlistqos pql pql-index protocol ip[ queue-key key-value ] queue{ bottom | middle | normal | top }orqos pql pql-indexinbound-interface interface-typeinterface-number queue { bottom| middle | normal | top }orqos pql pql-indexlocal-precedencelocal-precedence-value queue{ bottom | middle | normal | top }RequiredUse a command as needed.Specify thedefault queue forthe PQ listqos pql pql-index default-queue{ bottom | middle | normal | top }OptionalThis command specifies thequeue to which unmatchedpackets are assigned to.By default, unmatched packetsare assigned to the normalqueue.Set the queuesizeqos pql pql-index queue { bottom |middle | normal | top }queue-length queue-lengthOptionalEnter interfaceviewinterface interface-typeinterface-number —Apply the PQ listto the interface qos pq pql pql-index RequiredFIFO applies by defaultDisplay PQ listconfigurationinformationdisplay qos pq interface[ interface-type interface-number ]OptionalAvailable in any view