H3C s5800 series Troubleshooting Manual

Also see for s5800 series: Installation manual Instruction manual Command reference Quick start Command reference

Contents

H3C s5800 series Troubleshooting Manual Manual pdf 10 page image

7NOTE:Typically the irf auto-update enable command can automatically synchronize a member chassis withthe software version of the master chassis. However, the synchronization might fail when the gapbetween the software versions is large.7. If the problem persists, contact H3C Support.Related commandsThis section lists the commands that you might use for troubleshooting IRF.Command Descriptiondisplay interfaceDisplays interface information.Use this command to verify that each IRF port has at least onephysical port in up state.display irfDisplays IRF fabric information, including the member ID,role, priority, bridge MAC address, and description of eachIRF member.display irf configurationDisplays basic IRF settings, including the current member ID,new member ID, and physical ports bound to the IRF ports oneach IRF member device. The new member IDs take effect atreboot.display irf topology Displays the IRF fabric topology, including the member IDs,IRF port state, and adjacencies of IRF ports.display version Displays system version information.irf-port-configuration active Activates IRF configuration on IRF ports.