HAI Omni Pro II Owner's Manual

Also see for Omni Pro II: Installation Installation manual Quick reference Installation manual

Contents

HAI Omni Pro II Owner's Manual Manual pdf 16 page image

Page 8What Happens When You Arm the Security SystemTo arm the system into one of the 6 security modes, from the security menu, choose the security mode and press the appropriatekey (1 - 6), and then enter your user code number on the console keypad or use one of the Shortcut Keys as described.¾ The console will beep once and the console LED will be set to red¾ The controller will cycle power to reset smoke detectors¾ The top line will display the security mode.¾ The bottom line will display, " *** ARMING SYSTEM *** " to indicate that the system is being armed.The system will be fully armed after the Exit Delay expires.If arming in Away or Vacation mode:¾ Consoles configured with Audible Exit Delay enabled, will beep until the Exit Delay has expired. During the last 10second of the Exit Delay, the console will beep twice as fast; so leave and close the door promptly.¾ If enabled, “Exit Time Restart” will restart the exit delay if the same zone is violated twice within the original exit delay.For example, after arming the system if you open the front door to leave, close the front door behind you, and thenreenter through the front door while the exit delay is still in effect, the exit delay will be restarted. This is designed togive you additional time to exit without causing an alarm. The exit time will only be restarted once within a givenarming period.¾ If “Unvacated Premises” is enabled, if no exit zone is violated during the exit delay (i.e. the premises was not vacated),the system will automatically arm to Day mode at the expiration of the exit delay.NOTE: In Commercial Burglar Alarm Applications for UL Certified Systems, a Ring-back indication and Bell-test should beheard after arming (closing). If not heard, call for service.Exit ErrorThe Exit Error feature is designed to prevent accidental alarms caused by an error while arming. If an entry-exit zone is“Not Ready” (unsecured) when the exit delay expires, the Exit Error sequence is initiated as follows:¾ The sounder(s) are activated¾ Console Entry Chime comes on¾ The console display indicates: " *** DISARM SYSTEM *** - PRESS OFF THEN CODE"¾ The system will wait the Entry Delay timeIf the security system is not turned off during the Entry Delay:¾ The display shows the type of alarm and the violated zone: "BURGLAR ALARM! - ZONE NAME TRIPPED"¾ The system waits the Dial Out Delay, then if configured, begins to dial out¾ The central station will be sent a code representing the type of alarm, zone violated, and an Exit Error code¾ The When Alarm macro is activated (any associated programs will be executed)¾ The Flash For Alarm Unit Number begins to flash on and off.Note: The Exit Error feature is incompatible with “Auto Bypass”. If enabled, Auto Bypass will override this feature.