Page 78Entry/Exit ChimeWhen Entry/Exit Chime is set to Yes, the console(s) will beep once when a door on an entry/exit zone is opened, even if the alarmsystem is off. This lets you know when someone enters and leaves.The default setting for Entry/Exit Chime is Yes.Perimeter ChimeWhen Perimeter Chime is set to Yes, the console(s) will beep once when a window or any other perimeter zone is opened, even ifthe alarm system is off.The default setting for Perimeter Chime is Yes.Enable Quick ArmThe Quick Arm feature allows the security system to be armed by pressing the desired mode key twice instead of having to enteryour code.The default setting for Enable Quick Arm is No.Enable Auto BypassThe Auto-Bypass feature allows the system to automatically bypass an open zone when the system is armed, rather than setting offthe alarm. In some applications, it may be preferable to allow arming only if all zones are secure (READY).With Auto-Bypass set to “No”, all zones to be armed must be secure when the system is armed. Otherwise, the console will beepthree times and display "ZONE NOT RDY". If the system is armed and a zone is open when the Exit Delay expires, the alarmwill sound.The default for Enable Auto Bypass is No.All On For AlarmThis option will instruct OmniPro II to execute an X-10 All On command in the event that any type of alarm occurs.Beep On TroubleIf the OmniPro II detects any troubles with itself or one of the zones connected to it, it will display a message on the screen andbeep the console twice per second, continuously (i.e. beep beep...beep beep...). You can silence this sound by pressing the ' * 'key. However, if the trouble occurs again, the beeper will start beeping again.If you do not wish to hear the beeping sound when a trouble occurs, set Beep On Trouble to No.The default setting for Beep On Trouble is Yes.
