29English2.3.2 Setup WizardWhen turning on the TV for the first time, the SetupWizard is displayed to guide you through the basicconfiguration of the TV.1 Press / on the remote control to set the OSDLanguage. The available options are: English,Español, and Français. Press OK to confirm yourselection.2 Press / on the remote control to set theenvironment. The available options are: Home andStore. Press OK to confirm your selection.3 Press / on the remote control to set the TimeZone. The available options are: Eastern, Central, Mountain, Pacific, Alaska,and Hawaii. Press OK to confirm your selection.4 Press / on the remote control to set the TV RF Source. The availableoptions are: Air and Cable. Press OK to confirm your selection.5 Press OK on the remote control to start the channel scan. After completion, theTV automatically switches to the first channel found.2.3.3 Switching Source SignalsPress INPUT on the control panel or remote control to select the incoming signalsource to suit your need. Press OK to confirm.2.3.4 Performing an Automatic Channel SearchBefore using the TV to view programs, you need to activate the channel search firstif you skip the channel scan in Setup Wizard (see “Setup Wizard” on page 29).1 Press MENU on the control panel or remote control, then select to enter theChannel menu.2 Select Antenna to set the signal source to Air or Cable.3 Select Scan Mode to set the search mode to Auto (scan all channels), Analog(analog channels only), or Digital (digital channels only).4 Select Auto Scan, and if Cable is selected in the Antenna option, set the analogchannel system to Auto, Standard, HRC, or IRC.5 Select Start and press OK to perform the channel search. The ScanningMessage will be shown. After completion, the screen will switch to the firstchannel found.EnterOKOKExitMenuMenuMoveExitReturnReturnEnglishEspañolFrançaisSetup Wizard 1OSD Language