23Installation3.3.4 Connections (bottom of instrument)Cable protection shieldThe cable protection located at the bottom of the instrument (Figure 7 below) must be lowered,and eventually removed, to get access to the bottom of the instrument.Pull the plastic protection firmly towards you, then lower it as shown in Figure 8 below. Toremove it completely, push it back against the wall. Proceed in reverse order to install the cableprotection. Make sure the 4 pins are securely in place.Front panel doorA square key is provided to open the instrument front panel locks. The two locks are located onthe right side of the instrument on the top and bottom panels (number 9 in Figure 9 below).The front panel can be easily pivoted to the left as shown in Figure 8 below. To retain theinstrument waterproof tightness, make sure the seal is clean and in good condition beforeclosing the front panel.Note: The type of power cable connection will vary depending on the instrument specification.Figure 7 Cable protection shield in placeFigure 8 Cable protection shield lowered Figure 9 Wall/pipe mount connection panel1 - Power cable 6 - External pressure sensor connection2 - USB-B 4 pin connector (reserved formanufacturing)7 - Input/Output 2 cable gland3 - Ethernet cable gland 8 - Input/Output 1 cable gland4 - Sensor connection 9 - Keylock5 - USB-A host connector for mass storage device
