Hach SC4200c User Manual

Also see for SC4200c: Quick guide Basic user manual User instructions User instructions User instructions

Hach SC4200c User Manual Manual pdf 26 page image

Operate the web server application1. Select Modem menu to configure the modem.2. Select Ethernet menu to configure the Ethernet interface to get access to the internet and to theMSM.3. Select Maintenance and select an option.Option DescriptionNetworkstatusShows the settings of the controller network interfaces, used to access the MSM. Shows aconnectivity report and possible solutions to connectivity issues.• Internet connection—Shows the internet and Tenant connection status.• LAN connection—Shows the cable connection status. Shows the MAC and IP addressdata. Shows the switch status (ethernet port for network sharing).• Wireless• WiFi connection—Shows the dongle connection status and the signal strength. Showsthe network name and IP address and subnet mask data.• Mobile connection—Shows the modem and SIM connection status and the signalstrength. Shows the provider name. Shows the Roaming and APN (modem settings)status. Shows the internet connectivity status (data transmission and data limit).SC device list Shows the MSM connectivity status for the expansion modules, sensors and controller.• Controller—Shows the controller name, controller ID and data for Cloud connectivitycondition.• Modules—Shows module name, module ID and data for Cloud connectivity condition.• Sensors—Shows sensor name, sensor ID and data for Cloud connectivity condition.Versions Shows the software version of the controller.Logs andHistoryShows the historical data (i.e., configuration and log events) of the controller.Restart Sets the controller to off and on again.Factory reset Sets the controller history, modem and Ethernet configurations back to factory settings.Connect the instrument to a networkThe instrument must connect to a network with internet connectivity for configuration and operation.Based on the version, the controller connects to the internet with a cellular network, WiFi network ora LAN connection.LAN connectionThe instrument is factory configured with two subnetworks. This configuration uses the two ethernetports separately, one for internet access and the other one for TCP/IP based fieldbus communicationwith PLC/SCADA. To change the Ethernet port configuration and use the port for network sharing,refer to Share the LAN on page 25.1. Use a user-supplied ethernet cable (M12 to RJ45) to connect the controller to a device withinternet connection. Refer to Electrical connectors and fittings on page 13.Note: Connect the ethernet cable to the right ethernet connector.2. Connect the controller to a PC or laptop. Open the Web server application. Refer to Web serverapplication on page 22.3. Go to the Ethernet configuration page and configure the LAN connection.Note: An internet connection is not necessary to complete this configuration.4. Open the web browser on the PC. Enter the IP address that follows to connect to the SC4200ccontroller: "http://192.168.165.30"24 English