Hach sc200 User Manual

Also see for sc200: Quick guide Software update Basic user manual User manual User manual

Hach sc200 User Manual Manual pdf 21 page image

After the language, date and time options are set for the first time, updatethe options as necessary through the sc200 Setup menu.1. In the Language screen, highlight a language in the options list andpush the ENTER key. English is the default language for the controller.The selected language is saved. The Date Format screen appears.2. In the Date Format screen, highlight a format and push the ENTERkey.The date and time format is saved. Next, the Date /Time screenappears.3. In the Date/Time screen, push the RIGHT or LEFT arrow keys tohighlight a field, then push the UP and DOWN arrow keys to updatethe value in the field. Update the other fields as necessary.4. Push the ENTER key.The changes are saved and the controller performs a start-up scan fordevices. If connected devices are found, the controller displays themain measurement screen for the device in the number one position.If the controller fails to find connected devices, refer toTroubleshooting on page 35.Adjust the display contrast1. From the Settings Menu, select sc200 Setup.2. Select Display Contrast.3. Use the UP and DOWN arrow keys to adjust the contrast to a valuebetween the minimum of +1 and the maximum of +9.Controller configuration informationGeneral information about configuration options is listed in the table. Step-by-step information for how to configure some of the options can be foundon the CD.1. To navigate to the menu options, from the Settings Menu, select sc200Setup.Option DescriptionSecurity setup Sets the passcode preferencesOutput setup Configures the controller analog outputsRelay setup Configures the controller relaysDisplay contrast Adjusts the contrast of the controller displaySet Date/Time Sets the controller time and dateDatalog setup Configures data logging options. (Available if Calculationhas been setup. At least one sensor must be attached toenter a calculation.)• Set Mode—Snap shot, Average, Maximum, Minimum.• Set Interval—5 sec, 30 sec, 1 min, 2 min, 5 min, 10min, 15 min, 30 minError Hold Mode Hold Outputs—Holds outputs at last known value whencontroller loses communication with the sensor.Transfer Outputs—Switches to transfer mode whencontroller loses communication with the sensor. Outputstransfer to a pre-defined value.sc200InformationS/W VER:—Displays the current version of controllersoftware.Bootloader VER:—Displays the current Bootloaderversion. The Bootloader is a file that loads the mainoperating system for the controller.S/N:—Displays the controller serial number.Edit name Assigns a name to the controllerLanguage Assigns the language used in the controller2. Select an option and push ENTER to activate the menu item.English 19