Hagie DTS 10 Manual

Also see for DTS 10: Operator's manual Manual Operator's manual

Hagie DTS 10 Manual Manual pdf 66 page image

7-11SECTION 7 –SPRAY SYSTEMSSpray System ConsoleRefer to the Spray System Consolemanufacturer’s operation manual forcomplete programming and operatinginstructions.SOLUTION SYSTEM -OPERATIONGetting Started1. Calibrate the Spray System Console(refer to the manufacturer’s operationmanual for calibration instructions).2. Ensure there is adequate amount of solu-tion in the tanks.3. Engage the parking brake.4. Start the engine.NOTE: Maintain a relatively low engineRPM setting (1,000 RPM). Increaseengine RPM slowly until fullrecommended throttle is obtained.Refer to “Specifications” in Section1- Introduction for furtherinformation.5. Press the Solution Pump Switch (locatedon the side console) in the UP (On) posi-tion.Master Spray Indicator(Located on the side console)-Typical ViewSpray System Console(Located near the side console)-Typical ViewMay vary in appearance dependingon model and available equipment.NOTICEThe Solution System has been testedusing RV-type antifreeze. Fill solutiontank with fresh water and drain beforeinitial use.NOTICENever attempt to operate the spraysystem without solution in the tanks.Failure to comply will cause severeequipment damage and will void thewarranty.