Haier HL24XK2 Owner's Manual

Also see for HL24XK2: Troubleshooting guide Service manual

Haier HL24XK2 Owner's Manual Manual pdf 15 page image

OperationHaier LCD HDTV EN-14When the maximum recording duration is reached,R the oldest program would be deleted and thelatest program is recorded.When changing channel or changing input source,Rthe timeshift would stop automatically.Time shift record will store the fact of no signal.RTime shift will store the video, audio and dataR service. we only support:Video streams: Max 1 streamAudio streams: Max 8 streamsCC stream: No limited.In recording, the data is not guaranteed to beRstored in the disk. If the timeshift playback playsa corrupted data block, it would show “Data lost”message to indicate that the current data is notstored correctly.Please connect the TV antenna or Cable TV coaxialRcable to the Antenna input on the TV. Then pleasecomplete the channel scan. The Time Shift featureis available when using your ATSC tuner and QAMcable tuner.Function Menu OptionsPressA MENU button and CH+/- button until thefollowing menu appears on the screen.FunctionLanguage EnglishOSD Timeout ShortOSD Transparency MiddleDCR OnBlue Screen OnTime SetupClosed CaptionDefaultSelectCH+/-VOL+/- BackEXITVideoAudioChannelLockFunctionDPMS OnScreen Mode NormalPressB VOL+/ ENTER button to enter the menu andCH+/- button to go up and down to select thedesired option.PressC VOL+/ ENTER button to confirm and VOL+/-button increase and decrease the level to adjust theselected option to your preference.Repeat step 2 and step 3 until desired quality hasD been achieved.FunctionLanguageY :Press VOL+/- button to select language ofthe OSD.OSD TimeoutY : Press VOL+/- button to select Middle/Short and Long to change thetime of the OSDdisplay.OSD TransparencyY : Press VOL+/- button to selectamong Low/High and Middle to change thetransparency of the OSD. To select Low, the OSD isopacity.Screen ModeY : Press VOL+/- button to select amongNormal/Wide/Zoom and Cinema to change thedisplay mode(display mode may differ from differentinputs).DPMSY : PC Power Management. When set On, the setwill be put in standby mode automatically if there isno signal received for 2 minutes.Blue Screen:Y Press VOL+/- button to select On, thescreen will be in blue after 3 seconds if there is nosignal.DCR:Y Dynamic Contrast Ratio. Press VOL+/- button toselect On or Off.Time Setup:Y Press VOL+/ ENTER button to enter thesubmenu.Time Zone:• Press VOL+/- button to select theappropriate time zone.Time SetupTime ZoneDate/TimeSleep Timer OffSelect BackEXITVideoAudioChannelLockFunctionCH+/-VOL+/-Date/Time:• Press VOL+/ ENTER button to enterthe submenu.Date/TimeAuto OnDate 2009/01/01Time 11:54 AMTimer OffOn Time 11:54 AMOff Time 12:00 AMSelect BackEXITVideoAudioChannelLockFunctionCH+/-VOL+/-Auto: Press VOL+/- button to select On or Off . WhenAuto mode on , the time can not be adjusted. Select