Color SystemBCAUsually this should be set in the auto position. However if the color displayedon the screen are incorrect, you can manually select the correct color system.Press MENU and then VOL+/- button, till the picture menu shown on theright will display on the screen.Press CH+/- buttons to select "Color Sys.", then press the VOL-/+ buttonsto select the correct color system. In general, you can set it as "AUTO".After the programs are presetting, you can skip some programs so that to select your favorite channels only.1. Press CH+/- button or Direct-digit choosing button to select a channel directly.2.Press MENU and then use VOL+/- button to select the SYS. Menu.3.Press CH+/- buttons to select "Skip" item.4. press VOL-/+ button to set Skip as On.5. When you are satisfied with your choice, press MENU button to return tothe previous menu or press EXIT button to return to TV viewing.1. Use Direct-digit Choosing button to select the number of the channel tobe recovered.2. Do the above steps again.3. Press VOL+/- button to set Skip as Off.SkipBCAIf you want to recover the skipped channel1 ..Press MENU and then use VOL+/- button to select the SYS. Menu2. Press CH-/+ button to select Prog.Switch.3. Press VOL+/- to enter the submenu, and press the digital button to set the desiredchannel number,Press CH+/- button to Current Prog or To Prog item, and VOL+/- to select the position then press the digital button to set theexchange channel number, press CH+ button to Switch, then press VOL+ button to confirm.4. When you are satisfied with your choice, press MENU button to return tothe previous menu or press EXIT button to return to TV viewing.Prog.SwitchCurrent Prog 000To Prog 001SwitchBCASystem MenuColor Sys. AUTOSound Sys. M/NFine Tune 49.75MHzSkip OffChannel Type CATVCATV Type STDAuto ScanProg. SwitchColor Sys. AUTOSound Sys. M/NFine Tune 49.75MHzSkip OffChannel Type CATVCATV Type STDAuto ScanProg. Switch