Haier HWR08XCJ Use & Care Manual

Contents

1. Remove the clear plastic film from the control panel.2. Press POWER to turn on the air conditioner. The Powerindicator light will turn on.NOTE: When the air conditioner is plugged in, the LED displaywill show “88” for 3 seconds. After the air conditioner is turnedon for the first time, the display will show the current roomtemperature and the fan is set to Low speed.3. Select mode. See “Mode.”4. Select fan speed. See “Fan Speed.”5. Set temperature. See “Temperature.”1. Press MODE until you see the indicator light glow for thedesired setting.2. Choose Fan, Cool, Energy Saver or Dehum.■ Fan—Only the fan runs. Press SPEED to select High, Medor Low fan speed. The display shows the current roomtemperature.■ Cool—Cools the room. Press SPEED to select High, Med orLow fan speed. Press the TEMP/TIME up or downarrow button to adjust the temperature.■ Energy Saver—Fan runs only when cooling is needed. PressSPEED to select High, Med or Low fan speed.Because the fan does not circulate the room air continuously,less energy is used, but the room air is not circulated as often.■ Dehum—Dries the room. The air conditioner automaticallyselects the temperature.NOTE:■ Dehum mode should not be used to cool the room.■ In Dehum mode,Please do not operate the speed button.1. Press FAN SPEED until you see the indicator light glow forthe desired setting.2. Choose High, Med or Low.■ High—for maximum cooling·Operating your air conditioner properly helps you to obtain thebest possible results.This section explains proper air conditioner operation.IMPORTANT:■ If you turn off the air conditioner, wait at least 3 minutes beforeturning it back on. This keeps the air conditioner from blowing afuse or tripping a circuit breaker.■ Do not try to operate your air conditioner in the Cool mode whenoutside temperature is below 61°F (16°C). The inside evaporatorcoil will freeze up, and the air conditioner will not operateproperly.AIR CONDITIONER USEStarting Your Air ConditionerModeFan Speed9