Haier WINE BANK 60 User Manual

Also see for 5: Quick start guide User manual User manual User manual User manual

EN Installation17Assembly steps(except HWS49GAE)1. Provide necessary tool.2. Unplug the appliance.3. Open the door, take down the front strip andside and placed on the right side of the gap.4. Unplug the connection cable.Pull-out the upperpart of the door seal, and take down the doorback strip. (Remove from the left side opening)5. Remove 2 screws on the upper hinge.6. Remove cover and hinge, remove axe coverthen assemble to the other side, then install thehinge in the axe.7. Remove the cam and door holder, move thedoor holder to another side of the door. Installthe new cam form the gift bag.8. Cabinet tilted (less than 45°), remove the bot-tom hinge (3 screws) for backup.9. Remove the lower hinge cam and hinge shaft.Install the shaft on the right side of the lowerhinge. Take out the cam from the instruc-tion bag and install it on the lower hinge shaft.10. Install the lower hinge and the bottom foot onthe other side of the cabinet. Lubricate the cam.11.the upper hinge with two screws on the cabinet.Fix the signal wires in the middle of the upperhinge groove, and take the hinge cover in theinstruction bag and fasten it on the upper hinge.12. Install the door seal and the door strip onthe door. Insert the pair of door signal wires,move the magnetic switch (12.1) to the rightmounting slot (12.2) of the upper beam box,and fasten the front trim of the cabinet.13. Make sure the door is able to open and close in agood condition.1 2345 6712.1 12.289101112