Haier WS50GA User Manual

Also see for WS25GA: User manual

2EnglishUnpacking Your Wine Cellar1. Remove all packaging material. This includes the foam base andall adhesive tape holding the wine cellar accessories inside andoutside.2. Inspect and remove any remains of packing, tape or printedmaterials before powering on the wine cellar.Leveling Your Wine Cellar• Your wine cellar has leveling legs which are located in the frontand rear corners of your wine cellar. After properly placing yourwine cellar in its final position, you can level your wine cellar.• Leveling legs can be adjusted by turning them clockwise to raiseyour wine cellar or by turning them counterclockwise to lower yourwine cellar. The wine cellar door will close easier when the levelinglegs are extended.Proper Air Circulation• To assure your wine cellar works at the maximum efficiency itwas designed for, you should install it in a location where there isproper air circulation, plumbing and electrical connections.• The following are recommended clearances around the winecellar:Sides.......................... 2" (50mm)Top............................. 2" (50mm)Back........................... 2" (50mm)• Do not over fill your wine cellar for proper wine cooling.Note: If your wine cellar has been tilted for any reason, wait 24 hoursbefore plugging it in.Installing Your Wine Cellar11.12.13.If the light is damaged, it must be replaced by themanufacturer, its service agent or similarly qualifiedpersons in order to avoid a hazard.This appliance is intended to be used exclusively for thestorage of wine.Risk of child entrapment. Before you throw away your oldwine cellar, take off the doors. Leave the shelves in placeso that children may not easily climb inside.