7 - 10 IMAGETEAM™ 4410/4710 User’s GuideResponsesThe Imager responds to serial commands with one of three responses:ACK Indicates a good command which has been processed.ENQ Indicates a bad command.NAK Indicates the command was good, but the entry was out of the allowablerange, e.g., an entry for a minimum message length of 100 when the fieldwill only accept 2 characters.Command Center ButtonsDisplay All Settings displays the settings currentlysaved for the Imager.Display Setting Ranges displays all the possibleserial commands and the allowable data fieldparameters.Display Firmware Rev displays the software versionbeing used by the Imager.Build Command Bar Code is used to create an Azteccode from a command or set of commands entered inthe Serial Window. (The size of the Aztec code can bealtered using the File - Preferences selection.) Thisbar code can then be printed out and used to programother Imagers.Build Clone Bar Code is used to capture the settings from one Imager, andinput them to another Imager. When the Build Clone Bar Code button is clicked,Quick*View captures the settings from the attached Imager and creates an Azteccode which can be printed. (The size of the Aztec code can be altered using theFile - Preferences selection.) Any Imager that scans the resulting clone barcode will be programmed to the same settings as the original Imager.
