IMAGETEAM™ 4410/4710 User’s Guide 7 - 27Imaging CommandsImage Commands Help FileIf you send the IMGCMD command to the imager, the imager sends out an ASCII“help file” that describes the available imager capture commands. Explanationsof the most commonly used imager capture commands follow.Image ShipAn image is taken whenever the trigger of the IT4410/4710 is depressed. Thelast image is always stored in memory. You may “ship” the image by using theIMGSHP command. The image ship command has many different modifiers thatcan be used to change the look of the image that is output by the scanner. Thedefault image file format used by IMGSHP is a gray scale KIM.IMGSHP ModifiersCompensation: flattens the image to account for variations in illuminationacross the image.0C - compensation disabled1C - compensation enable, defaultPixel Ship:can be used to decimate the image by shipping only certain regularlyspaced pixels. There is no limit to the number of pixels that can be skipped;although after a certain point, the image becomes unusable.1S - ship every pixel2S - ship every 2nd pixel, both horizontally and vertically, default3S - ship every 3rd pixel, both horizontally and verticallyImage Cropping: Ship a window of the imagexxxT - top of image with xxx indicating the pixel row at which to startshipping. Range: 000 - 480.xxxB - bottom of image with xxx indicating the pixel row at which to stopshipping. Range: 000 - 480.xxxL - left of image with xxx indicating the pixel column at which to startshipping. Range: 000 - 640.xxxR - right of image with xxx indicating the pixel column at which to stopshipping. Range: 000 - 640.Image File Format: Indicates the type of file format in which to save the image0F - KIM format, default1F - TIFF Binary2F - TIFF Binary Group 4 Compressed3F - TIFF Gray scale4F - Uncompressed Binary
