4600g, 4600r, 4800i User’s Guide 11 - 111 UtilitiesTo Add a Test Code I.D. Prefix to All SymbologiesThis selection allows you to turn on transmission of a Code I.D. before thedecoded symbology. (See the Symbology Chart, included in the AppendixA, page A-1) for the single character code that identifies each symbology.) Thisaction first clears all current prefixes, then programs a Code I.D. prefix for allsymbologies. This is a temporary setting that will be removed when the unit ispower cycled.Show Decoder RevisionScan the bar code below to output the decoder revision.Note: You may use the Show Decoder Revision option if you have firmware witha base number of 31205480. Refer to Show Software Revision on page11-2 for information on determining the firmware revision in your unit.Show Engine RevisionNote: You may use the Show Engine Revision option if you have firmware witha base number of 31205480.Scan the bar code below to output the engine revision. If your imager has an4X00 engine, it will return an [ACK] with no data in the string. If your imager hasan 5X00 engine, it will return the engine type, revision number, and statuscharacter [ACK]. For example, an imager with an 5100, version 26 would return:ENGREVType: 1 Revision: 26[ACK]Add Code I.D. Prefix toAll Symbologies (Temporary)Show Decoder RevisionShow Engine Revision
