Hand Held Products 4600g User Manual

Also see for 4600g: Application note Programming guide Programming guide User guide Quick start guide

Contents

Hand Held Products 4600g User Manual Manual pdf 58 page image

3 - 10 4600g, 4600r, 4800i User’s GuideImager Time-OutImager Time-Out powers down the imager after the unit has been idle for thespecified time. To prevent the imager from powering down, set this time-out to0. Scan the bar code below, then set the time-out by scanning digits (from 0 -999,999 ms) from the inside back cover, then scanningSave.Default = 60,000ms.Note: The default applies to firmware with a base number of 31205480. Referto the Show Software Revision on page 11-2 for information ondetermining the firmware revision in your unit.Aimer DelayThe aimer delay allows a delay time for the operator to aim the imager before thepicture is taken. Use these codes to set the time between when the trigger ispulled and when the picture is taken. During the delay time, the aiming light willappear, but the LEDs won’t turn on until the delay time is over.User-Specified Aimer DelayIf you want to set your own length for the duration of the delay, scan the bar codebelow, then set the time-out by scanning digits (0 - 4,000 ms) from theProgramming Chart inside the back cover of this manual, then scan Save.Imager Time-Out400 milliseconds* Off(no delay)200 millisecondsDelay Duration