Statement of Agency ComplianceThis device complies with part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference thatmay cause undesired operation.FCC Class A Compliance StatementThis equipment has been tested and found to comply with the limits for a Class Adigital device, pursuant to part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interference when theequipment is operated in a commercial environment. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmful interference to radiocommunications. Operation of this equipment in a residential area is likely tocause harmful interference, in which case the user will be required to correct theinterference at his own expense.Caution: Any changes or modifications made to this device that are notexpressly approved by Hand Held Products may void the user's authority tooperate the equipment.Note: To maintain compliance with FCC Rules and Regulations, cablesconnected to this device must be shielded cables, in which the cable shieldwire(s) have been grounded (tied) to the connector shell.Canadian NoticeThis equipment does not exceed the Class A limits for radio noise emissions asdescribed in the Radio Interference Regulations of the Canadian Department ofCommunications. (ICES-003)Le present appareil numerique n'emet pas de bruits radioelectriques depassantles limites applicables aux appareils numeriques de la classe A prescrites dansle Reglement sur le brouillage radioelectrique edicte par le ministere desCommunications du Canada. (ICES-003)