Hand Held Products Quick Check 200 Series User Manual

45Save data when a printer is not connected1. Scan a bar code symbol.2. Scan the appropriate special Print/Store Code. The Codes are located at theback of this manual. There are four codes, one for each type of Quick Checkprinter and one for a PC printer. You can save results from up to 25 scans inthis buffer and then connect the printer and print your results.OR3. Press Select [0] four times or until Store Data? appears. Press Select [0]again to store the data. The data is stored in the temporary buffer. You cansave results from up to 25 scans in this buffer. When you connect a printerand turn it on, you can print the data.Review data from the last scan:1. If the Quick Check is turned off, turn it on.The message, BUF XX% Ful appears.2. Press Scroll [<>]The message, Print Bufr? appears.3. Review the data, press Scroll [<>]Information from the last bar code scanned appears.Print or delete stored data:1. Connect your printer to the Quick Check and turn on both units.2. Turn on Quick Check.The message, Buf XX% Ful appears.3. Press Scroll [<>].The message, Print Bufr? appears.4. To print the stored data, press Scroll [<>] twice. After you press Scroll [<>]once, the message, **Confimr** appears. The Quick Check sends the datato the printer. After you press Scroll [<>] a second time, the message –Busy!- appears.OR5. To delete the stored data, press Select [0] twice. After you press Select [0]once, the message, Dump Buffr? appears. After you press Select [0] asecond time, the message, **Confimr** appears.