Handicare Freecurve Technical Manual

Also see for FREECURVE Basic: User manual

Handicare Freecurve3819 | RemotesLinking of the remotesRemotes are standard delivered with a lift, one for each charge/stopping point.The remotes operate on 868 Mhz.The remotes are used to transport a lift without a person.Stairlift StatusThe remote control unit’s LED indicates the stairlift’s status:Unlinking of the remotesThe pushbuttons can be unlinked from the print in the event of an error in the programming of the push-buttons or the need to replace the pushbuttons.The datacard should be taken for 3 seconds from the cardreader. Until you hear a beep.Take care: the lift is not disconnected from batteries or chargestationVideo of the linking of theremotesRemotesOperationwhen using remote controlwhen using remote controlwhen using remote controlwhen using remote controlwhen using remote controlwhen not using remote controlwhen not using remote controlSituationstairlift in start-up phase (3 sec)stairlift travellingstairlift stopped at an active charging stationstairlift is stopped at the end stop and will notdepart until it is called in the correct directionstairlift is out-of-order and can no longer departstairlift stopped at an active charging stationstairlift is stationary en route, i.e. not at a chargingstationLEDLED remains offLED turns onLED turns offLED remains offLED flashes twice a secondLED offLED flashes twice a second for 20 secondsafter operation has stopped, LED then turns off