Hardi RANGER 2000 Instruction Book

4.14 - Sprayer setupGeneral infoUnloading the sprayer from the truckWhen unloading with an overhead lifting device, please observe thelifting points as shown in the picture, and make sure that the straps orbelts used for lifting are strong enough.Before putting the sprayer into operationAlthough the sprayer has been applied with a strong and protective surface treatment on steel parts, bolts etc. in the factory,it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILLO or SHELL ENSIS FLUID) on all metal parts inorder to avoid chemicals and fertilizers discoloring the enamel. If this is done before the sprayer is put into operation for thefirst time, it will always be easy to clean the sprayer and keep the enamel clean for many years. This treatment should becarried out every time the protection film is washed off.Support jackThe support jack is stored in retracted position and secured by the linchpin when the sprayer is attached to the tractor.To retract the support jack: Lift the jack, then pull the linch pin out androtate the support jack into storage position. Replace linch pin to secure.