Hardi RANGER 2000 Instruction Book

5 - Operation5.9Filling Liquid chemicals by HARDI® TurboFiller (optional)1. Fill the main tank at least 1/3 with water (unless something else isstated on the chemical container label). See section “Filling ofwater”.2. Turn the handle at the bottom Suction Manifold towards “Maintank”. Turn top Pressure Manifold valve towards “TurboFiller” andthe bottom Pressure Manifold valve towards “Agitation”. Closeremaining valves.3. Engage pump and set to operating r.p.m. (540/1000).4. Open TurboFiller lid.5. Measure the correct quantity of chemical and fill it into the hopper.6. Engage the hopper transfer device by opening the TurboFillersuction valve (C) and the chemical will be transferred to the maintank.7. If the chemical container is empty, it can be rinsed by the ChemicalContainer Cleaning device. Place the container over the multi-holenozzle and press the lever (A).8. Place the rinsing wand inside the hopper and press the lever (D) torinse the concentrated chemicals from the hopper.9. Close the TurboFiller suction valve (C) and the TurboFiller lid.10. When the spray liquid is well mixed, turn top Pressure Manifoldvalve towards “Spraying” position. Keep P.T.O. engaged so thespray liquid is continuously agitated until it has been sprayed onthe crop. ATTENTION! The scale in the hopper can only be used if thesprayer is parked at level ground! It is recommended to use ameasuring jug for best accuracy.€ DANGER! Do not press lever (A) unless the multi-hole nozzle iscovered by a container to avoid spray liquid hitting the operator. ATTENTION! Rinsing device uses spray liquid to rinse containers for concentrated chemicals. Always rinse thechemical containers with clean water several times until they are clean before disposal. ATTENTION! The hopper rinsing device uses spray liquid for rinsing concentrated chemical from the hopper! TheTurboFiller must always be cleaned together with the rest of the sprayer when the spray job is done.