Hardi RANGER 2000 Instruction Book

5 - Operation5.13CleaningGeneral infoIn order to derive full benefit from the sprayer for many years the following service and maintenance program should befollowed. ATTENTION! Always read the individual paragraphs. Read instructions for service/maintenance jobs carefully beforestarting on the job. If any portion remains unclear or requires facilities which are not available, then for safety reasonsplease leave the job to your HARDI® dealer’s workshop. ATTENTION!Clean sprayers are safe sprayers.Clean sprayers are ready for action.Clean sprayers cannot be damaged by pesticides and their solvents.Guidelines1. Read the whole chemical label. Take note of any particular instructions regarding recommended protective clothing,deactivating agents, etc. Read the detergent and deactivating agent labels. If cleaning procedures are given, followthem closely.2. Be familiar with local legislation regarding disposal of pesticides washings, mandatory decontamination methods, etc.Contact the appropriate department, e.g. Dept. of Agriculture.3. Pesticide washings can usually be sprayed out on a soakaway. This is an area of ground that is not used for cropping.You must avoid seepage or runoff of residue into streams, water courses, ditches, wells, springs, etc. The washings fromthe cleaning area must not enter sewers. Drainage must lead to an approved soakaway.4. Cleaning starts with the calibration, as a well calibrated sprayer will ensure the minimal amount of remaining sprayliquid.5. It is good practice to clean the sprayer immediately after use and thereby render the sprayer safe and ready for the nextpesticide application. This also prolongs the life of the components.6. It is sometimes necessary to leave spray liquid in the tank for short periods, e.g. overnight, or until the weather becomessuitable for spraying again. Unauthorized persons and animals must not have access to the sprayer under thesecircumstances.7. If the product applied is corrosive, it is recommended to coat all metal parts of the sprayer before and after use with asuitable rust inhibitor.