Harman Kardon AVR 260 Owner's Manual

Also see for AVR 260: Service manual Specifications

Harman Kardon AVR 260 Owner's Manual Manual pdf 24 page image

24SYSTEM CONFIgURATIONSub ModeMove the cursor to the Sub Mode line to program bass management for thesubwoofer. The subwoofer’s setting depends upon how you programmed thefront left and right speakers.If you set the front speakers to a numeric crossover frequency, the•subwoofer setting will be LFE, and you won’t be able to change it.All low-frequency information will always be sent to the subwoofer.If you don’t have a subwoofer, we recommend that you either upgrade to full-range speakers or add a subwoofer to your system at the earliest opportunity.If you set the front speakers to LARGE, you may select from two possible•settings for the subwoofer.L/R+LFE: This setting sends all low-frequency information to the■subwoofer, including both information that would normally beplayed through the front left and right speakers and the special low-frequency effects (LFE) channel information.LFE: This setting plays low-frequency information contained in the left■and right program channels to the front speakers, and directs only theLFE channel information to the subwoofer.NOTE: The Speaker/Channel Indicators on the front panel of the receiver (seeFigure on page 31) will display the speaker size settings as follows.For each speaker configured numerically, a single box will appear in theposition for that speaker. For each speaker configured as LARGE, a doublebox will appear in its position. If a speaker is configured as OFF, no box willappear. The subwoofer will be indicated by a single box, or no box if nosubwoofer has been configured. The letters inside the boxes appear when adigital signal is being received that has that channel discretely encoded. Theletters flash when the signal is not present, such as when a DVD is paused.A line will connect the SBL and SBR boxes when a 6.1-channel signal isdetected, indicating that the same signal is playing through both speakers.Adjust Speaker Distance MenuAs explained above in Step Two – Measure Speaker Distances, sometimes thespeakers are placed at different distances from the listeningposition, whichcan muddy the sound, as sounds are heard earlier or later than desired.Even if all of your speakers are placed the same distance from the listeningposition, do not skip this menu.On the Manual Speaker Setup menu, move the cursor to the Distance line andpress the OK Button to display the Adjust Speaker Distance menu. See Figure12.Figure 12 – Adjust Speaker DistanceMenuThis menu requires you to enter the distance from each speaker to thelistening position, which you measured in Step Two – Measure SpeakerDistances and noted in Table A3 in the appendix.The default unit of measurement is feet. If you wish to change the unit tometers, press the Back/Exit Button until you return to the main AVR menu.Scroll down to the System line, and select it to view the System Settingsmenu. Scroll down this menu to the General AVR Settings section, and selectthe Unit of Measure line. Press the OK Button to change the setting from Feetto Meters.Use the KL Buttons to move the cursor to the Front Left line, press the OKButton then use the M N Buttons to change the measurement as needed.The values vary between 0 and 9 meters, with a default of 3 meters for allspeakers. Use the M N Buttons to move to each speaker in turn – Center,Front Right, Surround Right, Surround Back Right, Surround Back Left,Surround Left and Subwoofer, if present in your system.NOTE: When the multiroom system is in use, the surround back channels areautomatically assigned to the multiroom system, as mentioned earlier. Youwill not be able to adjust the delay settings for these channels, and the cursorwill skip past them.