Harman Kardon AVR 2700 Owner's Manual

Also see for AVR 270: Quick start guide Service manual

Harman Kardon AVR 2700 Owner's Manual Manual pdf 26 page image

26AVR Set Up the AVRSet Up the AVRIn this section, you will configure the AVR to match your actual system’s makeup.Although it’s possible to configure the AVR using only the remote and the messages onthe AVR’s front-panel display, it is easier if you use the full-screen menu system.Turn On the AVR1. Set the rear-panel Main Power switch to “On.” (The front-panel Power indicator willglow amber.)2. Press the front-panel Power button.PowerButtonMain PowerSwitchUnless you will not be using the receiver for an extended period of time, leave the MainPower switch set to “On.” When the Main Power switch is turned off, any settings youhave programmed will be preserved for up to four weeks.IMPORTANT NOTE: If the PROTECT message ever appears in the Message Display,turn off the AVR and unplug it. Check all speaker wires for a short-circuit (“+” and“–“ wires touching). If none is found, bring the unit to an authorized Harman Kardonservice center for inspection and repair before using it again.Using the On-Screen Menu SystemTo access the menu system, press the AVR button on the remote or the Setup button onthe front panel. The Main Menu will appear, and if a video source is playing, it will bevisible behind the menu.Source SelectSelect the Source DeviceSetup SourceSetup Source DevicesSpeaker SetupSpeaker Optimization, EQZone 2Manage and Control Zone 2SystemGeneral AVR SettingsSettings LockManage System LockNOTE: When you are using the AVR’s on-screen menu system, we recommend a videooutput resolution of 720p or higher for easiest viewing and for graphics that simplifysome configuration options. Depending on the resolution selected, the menus shown byyour system may vary in appearance from the illustrations.The Main Menu system consists of six submenus: Source Select, Setup Source, SpeakerSetup, Zone 2, System and Settings Lock. Use the Up/Down/Left/Right buttons on theremote or the front panel to navigate the menu system, and press the OK button to selecta menu or setting line, or to enter a new setting.The current menu, setting line or new setting will appear in the front-panel MessageDisplay, as well as on screen.To return to the previous menu or exit the menu system, press the Back/Exit button. Becertain all settings are correct, as any changes you have made will be retained.Most users should follow the instructions in this Set Up the AVR section to configure abasic home theater system. You may return to these menus at any time to make additionaladjustments, such as those described in the Advanced Functions section, on page 33.Before beginning the following setup steps, all loudspeakers, a video display and allsource devices should be connected. You should be able to turn on the AVR and view themain menu when you press the AVR button. If necessary, reread the Making Connectionsand Set Up the Remote sections before continuing.Configure the AVR for Your Speakers1. Plug the supplied EzSet/EQ microphone into the AVR’s Headphone connector.AVRHeadphoneConnectorEzSet/EQMicrophone(supplied)2. Place the microphone at ear height in your listening position. The microphone featuresa threaded insert on the bottom for mounting on a camera tripod.3. Set the volume control on your subwoofer to approximately the halfway point.4. Turn on your TV and select the TV input where you connected the AVR in Connect YourTV or Video Display, on page 17.