Harman Kardon AVR45 Owner's Manual

Also see for AVR45: Owner's manual Service manual

Harman Kardon AVR45 Owner's Manual Manual pdf 24 page image

System Configuration3. Press the Set button i ˜.4. Adjust the delay time by pressing the⁄ / ¤ buttons g on the remote orthe Selector buttons ¸ on the frontpanel until the delay time figure cal-culated using the formula enteredabove appears in the display.5. If no adjustment is needed forthe center channel delay, press theSet button i ˜ to enter thesetting into the AVR45’s memory.If the calculations outlined abovefor the center channel delay requirean adjustment, proceed with thefollowing steps:6. Select a digital input by pressingthe Digital button w ˆ. Pressthe ⁄ / ¤ buttons g on the remoteor the Selector buttons ¸ on thefront panel until either COAX orOPTICAL appear in the MainInformation Display S . Note thatfor this adjustment, either input maybe selected.7. Press the Set button i ˜.8. Select the Dolby Digital mode eitherby pressing the front panel DolbyDigital Selector ( or by pressingthe Surround Mode Selector yon the remote, and then pressing the⁄ / ¤ buttons g on the remoteuntil DOLBY AC-3 appears in theMain Information Display S .Ignore any “NO DATA” messagethat may appear.9. Press the Delay button v ı onthe remote or front panel. The wordsS DELAY TIME appears in theMain Information Display S .10. Press the ⁄ / ¤ buttons g on theremote once, so that C DELAYTIME appears in the MainInformation Display S .11. Press the Set button i ˜.12. Press the ⁄ / ¤ buttons g onthe remote until the desired delaytime for the center channel appearsin the display.13. Press the Set button i ˜ to enterthe setting into the AVR45’s memory.Congratulations! You have now completedthe setup, adjustment and calibration ofthe AVR45. You are now ready to enjoy thefinest in music and home theater listening.21