Harman Kardon DVD 10 User Manual

8Rear Panel1 2 3 46 7 8 9951. OPTICAL OUT: Use optical cable (not provided) to connect your DVDPlayer to a compatible Dolby Digital or DTS receiver or decoder. DolbyDigital and DTS offer theater-quality sound (5.1-Channels).2. COAXIAL OUT: Use coaxial cable (not provided) to connect your DVDPlayer to a compatible Dolby Digital or DTS receiver or decoder. DolbyDigital and DTS offer theater-quality sound (5.1-Channels).3. AUDIO OUT: Insert audio cables (left and right) to these jacks onyour DVD Player and to the corresponding Audio Input jacks (left andright) on your TV or receiver.4. S-VIDEO OUT: If your TV has an S-Video jack, you can connect anS-Video cable to your TV and to your DVD Player for improved videoquality. The S-Video cable only carries the video signal; remember toconnect the left and right audio cables.5. VIDEO OUT: Connect a video cable to this jack and to the VideoInput jack on your TV. The video cable only carries the video signal;remember to connect the left and right audio cables.6. SCART OUT (AUX): If an external playback unit has a SCART socket,you can connect a SCART cable to it and to your DVD Player. TheSCART cable carries both audio and video signals of the external unit.These signals will be routed through the SCART connector of the DVDto the TV when the DVD player is turned on.7. SCART OUT (TV): If your TV has a SCART socket, you can connect aSCART cable to your TV and to your DVD Player for improved videoquality. The SCART cable carries both audio and video signal.Your DVD10 is equipped with two SCART connectors, one for directconnection to the TV, the second for throughput of VCR (playbackonly) or any other playback video source to a TV with only one SCARTinput.8. Remote IR Input: Connect the output of a remote infrared sensor orthe remote control output of another compatible Harman Kardonproduct to this jack. This will enable the remote control to operateeven when the front-panel Remote Sensor on the DVD10 is blocked.This jack may also be used with compatible IR remote control basedautomation systems. Remote IR Output: Connect this jack to the IRinput jack of another compatible Harman Kardon remote controlledproduct to have the built-in Remote Sensor on the DVD10 provide IRsignals to other compatible products.9. AC CORD (230V / 50Hz): Plug AC Cord to an unswitched 220-240Volt AC outlet.Note: you’ll find more details about all Audio/Video connections underSetup and Connections on the following pages.