Harman Kardon DVD 10 User Manual

9Setup and Connections• Ensure that the power switch of this unit and other equipment to beconnected is set to off before commencing connection.• Do not block ventilation holes of any of the equipment and arrangethem so that air can circulate freely.• Read through the instructions before connecting other equipment.• Ensure that you observe the color coding when connecting audio andvideo cables.• Select the appropriate screen shape at the initial setting “TV Aspect ”according to your TV set (4:3 or 16:9), see page 26.TVTo S-Video inputTo audio input (red/white)To power outlet (AC 230V/50 Hz)To video input(yellow)Note:• If the DVD/CD player is connected to the TV through a video cassetterecorder, the picture may not be played back normally with some DVDs.If this is the case, do not connect the player via the VCR.• The S (separate) video output connector separates the color (C) andluminance (Y) signals before transmitting them to the TV set in order toachieve a sharper picture. Use the S-video cable (optional) when con-necting the player to a TV set equipped with an S-video input forimproved picture clarity.• Most European TV´s are equipped with SCART connectors rather thanwith a normal video input (yellow cinch). In that case the SCART con-nection should be used, providing the audio signal too, (see page 8).Use separate analog audio connections to TV only if your TV isconnected to the video or S-video output.• When the audio signal is fed to stereo or Pro Logic amplifiers/decodersor receivers rather than to the TV, connect the Audio Out jacks to anynormal audio input on your amplifier/decoder/receiver. The DVD10 will”downmix” Dolby Digital recordings to Pro Logic, available on theseconnectors, all analog surround or stereo signals will be fed to themdirectly.Connecting to a stereo TV set and stereo or Pro Logic Amplifier/Receiver