Harman Kardon Digital Lounge 232 EX/240 HD Owner's Manual

Also see for Digital Lounge 232 EX: Handleiding

Harman Kardon Digital Lounge 232 EX/240 HD Owner's Manual Manual pdf 22 page image

22 INSTALLATION AND CONNECTIONSInstallation and ConnectionsFor analog tuner: proceed as follows:When you press the Enter Button 6 to confirm,the automatic channel search will start to scanthe available TV channels. The automatic searchcan take several minutes, depending on the num-ber of channels that are available.Figure 1d• Should you wish to abort the automaticchannel search, please press the Red ButtonN on your remote control.If no TV channel is found, check the aerial con-nections and attempt to search for the channelsagain.When the automatic search is finished, the EditChannel List Menu will show on your screen. Itwill show all the TV channels found indicated bya name consisting a maximum of 5 characters.This menu allows you to sort the TV channelsaccording to your preferences. Move the blue barby pressing the L Button until the TV channelyou would like to move is highlighted by the bluebar. Press the Enter Button 6 so that the barturns white. You can now move it up, down, leftor right with the K/L/M / N Buttons 9 until itis at the requested preset. Press the Enter Button6 to confirm. The white bar will turn blue toconfirm. Continue with all the other channelsuntil each preset contains your preferred TV chan-nel.The menu also allows you to delete TV channelsfrom your channel list. Move the blue bar to theTV channel to be deleted using the K/LButtons 9. Press the Green Button O todelete the TV channel.When you are done making changes to theChannel List, press the Red Button N toremove the list from the screen.Digital TunerIf you have selected the digital tuner (DVB-T),proceed as described below.Figure 1eYou will now be asked whether you use anactively powered antenna. Select either "On" or"Off" by using the K/L Buttons 9.The following automatic search screen will show:Figure 1fPress "Enter" to start the scanning process.Scanning may take several minutes, and you willsee a status screen keeping you updated as tohow many percent of the scanning has been per-formed. You can interrupt the scanning at anytime by pressing the OSD button . Whenscanning is complete, you will be asked to savethe new channels, and you are informed howmany channels were found.(If no channels are found, check the antenna con-nection. If you have used and indoor antenna, itmay be necessary to use an outdoor antennainstead. It may be a good idea to check with yourTV network provider if there is DVB-T coverage inyour area at all. If not, use analog tuner orcable/satellite reception instead). Press "Enter"to confirm the line "Yes, add new channels". Ifyou want to completely replace an earlier versionchannel list, press the N button to select "Yes,replace old channel list" and confirm with the"Enter" Button. If you do not want to save anynew channels, press the N Button to select "No,discard new channels" and confirm with the"Enter" Button. After confirming, the followingscreen will show:Figure 1gPress the Setup Button button 8 to close theSearch for Channels menu and start watching TV.Remember that once inside the menu system, yousimply press the "OSD"(On Screen Display) but-ton to return to the previous screen and the"Setup Menu" button to exit the menu systementirely.If you want to change additional settings in theDVB-T menu, like sorting channels, watch techni-cal information or set security settings, press theOSD Button once to go back one level, fol-lowed by the K/L Button 9 to select themenu you want (when coming directly from theChannel Search function).If you want to change settings for the DVB-Ttuner when watching TV, press the "Set-UpMenu" button 8 to enter the Setup Menu withthe TV heading showing black, press the [arrowdown] button 9 twice to move the indicatorbar down to the DVB-T Setup line and press"Enter" 6. The screen changes to System set-tings, with the blue dot at the left side indicatingwhich menu point you have chosen. The topmenu line states the name of the menu item inthe following order, downwards: System Settings,Search for Channels, Sort Channels, TechnicalInformation and Security. You select the menuyou want by scrolling down and up with theK/L Buttons 9. Notice that the bottommenu line offers further explanation for the menuyou have selected. Press "Enter"6 to enter thedetailed menu inside each main menu, and press"OSD" to return to the previous menu. Onceinside a detailed menu, you may alter various set-tings.