SPEAKER CONNECTIONS 11Dolby Pro Logic*(Non-Digital) – Line LevelUSE THIS INSTALLATION METHOD FORDOLBY PRO LOGIC APPLICATIONS (NOTDOLBY DIGITAL, DTS OR OTHER DIGITALPROCESSING), WHERE THE RECEIVER/PROCESSOR IS EQUIPPED WITH A SUB-WOOFER OUTPUT, OR A VOLUME-CONTROLLED PREAMP (LINE-) LEVELOUTPUT:Use the supplied RCA-type interconnectcable to connect the line-level subwooferoutput on your receiver or amplifier to eitherthe left or right Line-Level Full-RangeInput § on the SUB-TS7 subwoofer. Useboth the left and right inputs on the sub-woofer if your receiver or processor hasboth left and right line-level outputs. In thatcase, you will need to supply a secondinterconnect cable.If your receiver is equipped with line-level out-puts but does not have a separate subwooferoutput, use a Y-adapter (not supplied) tobridge the receiver’s preamp output to themain amp input for that channel, and connectthe long end of the adapter to the corre-sponding line-level input on the SUB-TS7.IMPORTANT: Do not use the SUB Input∞ on the subwoofer with Dolby Pro Logicprocessors.If your receiver/processor has a built-in low-pass-crossover filter for the subwoofer out-put, you may use the SUB Input ∞ tobypass the subwoofer’s internal crossover.Connect each speaker to the correspondingspeaker terminals on your receiver or amplifier.Make sure that you have configured yoursurround sound processor for “SubwooferOn.” The front left, front right, center andsurround speakers should all be set to“Small.”When all connections have been made, plugthe AC power cord on the subwoofer intoan AC outlet.SPEAKER CONNECTIONSReceiverSUB/LFEOutFrontLeftSurroundLeftFrontRightSurroundRightSUB-TS7SubwooferCenterLine-LevelR L– +– +– +– +– +SurroundRightFrontRightSurroundLeftFrontLeftCenter