Harman Kardon HS 210 User Manual

Also see for HS 210: Service manual

Harman Kardon HS 210 User Manual Manual pdf 18 page image

1818= Learning-CapableTeaching Codes to the Remote ControlPlace the1 HS 280/HS 210 remote head to head with the remote from whichyou want it to learn codes Put them about 1 inch (2 5cm) apart, with their IRtransmitter windows facing each otherPress and hold either the TV or Video button on the2 HS 280/HS 210 remoteLearn Button TV ButtonVideo ButtonLearn Button TV ButtonVideo ButtonWhile pressing the TV or Video button, press and hold the Learn button until its3LED begins flashing amber (The TV or Video button will not flash but will remainsteadily illuminated ) The flashing indicates that the remote is in the learningmodePress the4 HS 280/HS 210 remote button to which you want to teach thecommand The Learn button’s LED will then illuminate continuously The learningmode will remain active for 20 seconds after the button is pushedNOTE: If you accidentally press a button that is not learning-capable, the Learnbutton's LED will continue to flash amber and the remote will remain in the learningmodePress the button on the other remote that you want to “teach” the5 HS 280/HS 210remote When the HS 280/HS 210 remote has received and stored the otherremote's IR code, the Learn button’s LED will change to green, and the HS 280/HS 210 remote will remain in the learning mode, ready to learn another codeNOTE: If the HS 280/HS 210 remote can’t read the IR code from the other remote,the Learn button’s LED will flash red rapidly three times, and the remote will remainin the learning mode Resume programming from Step 4 If the HS 280/HS 210’sremote control does not receive an IR code within five seconds, the Learn button's LEDwill flash red rapidly three times, and the remote will remain in the learning modeResume programming from Step 4Repeat6 Step 3 and Step 4 for each command you want to teach the HS 280/HS 210remote You can switch between programming TV and video component codesby pressing the TV or Video button before resuming Step 4 NOTE: If the Learnbutton’s LED goes out at any time, you will need to repeat Step 2 through Step 6Using the Remote Control After it is ProgrammedPressing the remote’s TV button will put the remote into the TV-control mode It willcontrol the TV via the codes you have programmed into it Pressing the remote’s Videobutton will put the remote into the video-control mode, and it will control the videocomponent via the codes you have programmed into itTo switch the remote control back to the HS 280/HS 210 receiver-control mode fromthe TV-control or video-control mode, press any of these buttons: Disc, Radio, USB,Network, Activity or BookmarkSetting up the ReceiverNOTE: The on-screen menus shown in this manual are for illustrative purposes andmay differ slightly from the actual displaysUsing the On-Screen Menu SystemWhen you turn your HS 280/HS 210 receiver on for the first time, the on-screen menuwill display the Activity menu This menu acts as the HS 280/HS 210’s “home” screenAll of the HS 280/HS 210’s on-screen functions originate in the Activity menuTo operate your HS 280/HS 210 system, you will use the remote control to navigatethrough all of the on-screen menus and make selections from themCursor ButtonsEnter ButtonEnter Button Cursor Buttons= Learning-Capable