12/20/11 888-2595-001 A-5WARNING: Disconnect primary power prior to servicing.Appendix A - FM Web Remote OptionZX SeriesSTEP 11 Attempt to access configuration page via procedure in section A.5.1.Default password is "expert". Default IP address is 192.168.1.99 unlessotherwise indicated.NOTE:To access the web remote for the first time, there are two different options:• 1:1 connection to PC: Use a crossover type cable, and the PC should have itsIP address manually set to 192.168.1.xx, where xx is 0-255, but not 99.• Connection to router: Some router types use a default address of192.168.1.1. (e.g. LINKSYS) In such a case, the web remote may beconnected directly to the router via a straight (non-crossover) cable.STEP 12 If web remote will not respond to IP address of 192.168.1.99, perform anexpert reset per procedure in section A.5.3.STEP 13 On configuration page, set IP address to final desired address. Whereindicated, access router configuration page and set port 80 forwarding toweb remote IP address. Set other user parameters per information givenin Table A.5.1.STEP 14 Access main page via procedure in section A.3.1.STEP 15 Verify web remote properly commands and monitors transmitter.STEP 16 Change configuration settings as desired until satisfied with all aspectsof web remote operation (passwords, SMTP, SNMP, etc).STEP 17 Record all configuration settings on paper and store in safe place forfuture reference. (passwords, addresses, etc)STEP 18 Procedure complete.A.3 OperationAll monitoring, logging, and commands are on a single, straightforward, main webpage. Use this procedure to access the main page.A.3.1 Access main pageSTEP 1 Open web browser on PC.STEP 2 Enter IP address of web remote (preceeded by http://) on address lineand press RETURN.STEP 3 Empty page with "PASSWORD?" prompt should be displayed.
