IBM 2179 Hardware Maintenance Manual

Also see for 2179: User guide Technical information manual User guide Podręcznik użytkownika

Contents

Diagnostic Error Code FRU/Action020-199-XXXPCI test failed, cause unknown 1. Go to the ″Undetermined problems″section2. Flash the system and re-test3. Replace component under function test020-262-XXXPCI system error 1. PCI card2. Riser card, if installed3. System board025-000-XXXIDE interface Test Passed 1. No action025-00X-XXX025-01X-XXXIDE interface failure1. IDE signal cable2. Check power supply3. IDE device4. System board025-027-XXXIDE interface Configuration/Setup error 1. IDE signal cable2. Flash the system3. IDE device4. System board025-02X-XXX025-03X-XXX025-04X-XXXIDE Interface failure1. IDE signal cable2. Check power supply3. IDE device4. System board025-195-XXXIDE interface Test aborted by user 1. Information2. Re-start the test, if necessary025-196-XXXIDE interface test halt, error thresholdexceeded1. Press F3 to review the log file2. Re-start the test to reset the log file025-197-XXXIDE interface test warning 1. Make sure the component that is calledout is connected and/or enabled2. Re-run test3. Component that is called out in warningstatement4. Component under test025-198-XXXIDE interface test aborted 1. If a component is called out, make sureit is connected and/or enabled2. Flash the system and re-test3. Go to the ″Undetermined problems″section025-199-XXXIDE interface test failed, cause unknown 1. Go to the ″Undetermined problems″section2. Flash the system and re-test3. Replace component under function test030-000-XXXSCSI interface Test Passed 1. No actionChapter 5. Symptom-to-FRU Index 47