IBM 5886 Installing

Also see for 5886: Removal and replacement procedures

f. Install the left bezel, which contains the service indicators, and the right bezel. Fit the cutout onthe top of the bezel over the tab on the chassis flange. Rotate the bezel down until it snaps intoplace. Make sure that the inside surface of the bezel is flush with the chassis.5. If you have disk units that require installation to the disk drive enclosure, repeat this step now foreach disk unit to be installed into the enclosure.Attention: Use the following precautions whenever you handle electronic components:v Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostaticdischarge from damaging your hardware.v If you do not have a wrist strap, just prior to removing the product from ESD packaging andinstalling or replacing hardware, touch an unpainted metal surface of the system for a minimumof 5 seconds.v Keep all electronic components in the shipping container or envelope until you are ready to installthem.v If you remove, then reinstall an electronic component, temporarily place the component on anESD pad or blanket, if available.Figure 8. Routing the power cords through the cord retention bracketsFigure 9. Attaching the side bezels8 Power Systems: Installing the 5886 disk drive enclosure