IBM 6339 User Manual

Also see for 2256: Hardware Maintenance Manual User guide Hardware Maintenance Manual Guías del usuario Guide d'utilisation

Contents

IBM 6339 User Manual Manual pdf 35 page image

The following illustration shows the locations of the drive baysThe following table describes some of the drives that you can install in each bayand their height requirements.1Bay 1 - Max Height: 25.4 mm (1.0 in.) 3.5-inch diskette drive (preinstalled in somemodels)2Bay 2 - Max Height: 41.3 mm (1.6 in.) CD-ROM drive (standard in some models)3Bay 3 - Max Height: 12.7 mm (0.5 in.) 3.5-inch hard disk drive (preinstalled)Notes:1. Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.2. Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.Installing a driveTo install a CD drive or DVD drive in bay 2, follow these steps.1. Remove the cover (see “Removing the cover” on page 19).2. If you are installing a drive with removable media, insert a flat–bladescrewdriver into one of the slots on the static shield in the drive bay intowhich you installed the drive and gently pry the static shield loose from thedrive bay.3. Make sure the drive is set correctly as the master device. Refer to thedocumentation that comes with your CD drive or DVD drive for master/slavejumper information.4. Lift the latch and remove the drive mounting tray.5. Install the drive into the bay. Align the screw holes and insert the four screws.6. Slide the drive cage halfway into the mounting tray.24 User Guide