Notes:1. Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.2. Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.Installing a driveTo install an internal drive, follow these steps.1. Remove the cover. See “Removing the cover” on page 29.2. If your computer has a CD drive or DVD drive, you might need to remove thesignal and power cables from the drive.3. If the drive you installed is a removable-media drive, remove the bay panelfrom the front bezel.4. Remove the metal shield from the drive bay by inserting a flat–bladescrewdriver into one of the slots and gently pry it loose.5. Pivot the drive bay latch handle toward the front of the computer and pivot thedrive bay cage toward the front of the computer until the drive cage latchcatches to the chassis.6. Make sure the drive that you are installing is set correctly as either a master ora slave device.v If it is the first CD drive or DVD drive, set as a master device.v If it is an additional CD drive or DVD drive, set as a slave device.v If it is a hard disk drive, set as a slave device.Chapter 4. Installing internal options — desktop model 35