Profiler View103Profiler ViewFigure 82. Profiler ViewThe center part of the Media Profiler window is the profiler view. The profilerview is divided into three sections: the legend, ruler, and profile graphic.See Figure 82.LegendThe legend displays the current values for two thresholds: Sensor Type andPaper Out. These values are set to zero by default since no threshold valueshave been received. These values are updated when the capture starts.Sensor Type can be one of the following: Disabled, Mark, Gap, AdvancedGap, or Advanced Notch. By default it is set to Disabled. When dynamicsensing is enabled on the printer, the value of Sensor Type is Dynamic.The RulerThe ruler displays the length of the captured profile in inches. The ruler hassmall ticks every tenth of an inch, and a larger tick ever half inch. A resolutionof 300 DPI is used by default to determine the length. When the profilecapture starts the actual DPI will be retrieved from the printer and the ruler willupdate to reflect the correct DPI.Legend Ruler Profiler GraphicProfiler View
