IBM 7328C1U Installation And User Manual

Also see for System x3200 M3: Brochure & specs Product guide Product guide Service guide Product guide

Contents

In addition, you can download an LSI command-line configuration program fromhttp://www.ibm.com/systems/support/.When you are using the LSI Configuration Utility program to configure and managearrays, consider the following information:v The integrated SAS/SATA controller with RAID capabilities supports the followingfeatures:– Integrated Mirroring (IM) with hot-spare support (also known as RAID 1)Use this option to create an integrated array of two disks plus up to twooptional hot spares. All data on the primary disk can be migrated.– Integrated Mirroring Enhanced (IME) with hot-spare support (also known asRAID 1E)Use this option to create an integrated mirror enhanced array of three to eightdisks, including up to two optional hot spares. All data on the array disks willbe deleted.– Integrated Striping (IS) (also known as RAID 0)Use this option to create an integrated striping array of two to eight disks. Alldata on the array disks will be deleted.v Hard disk drive capacities affect how you create arrays. The drives in an arraycan have different capacities, but the RAID controller treats them as if they allhave the capacity of the smallest hard disk drive.v If you use an integrated SAS/SATA controller with RAID capabilities to configurea RAID 1 (mirrored) array after you have installed the operating system, you willlose access to any data or applications that were previously stored on thesecondary drive of the mirrored pair.v If you install a different type of RAID controller, see the documentation thatcomes with the controller for information about viewing and changing settings forattached devices.Starting the LSI Configuration Utility programTo start the LSI Configuration Utility program, complete the following steps:1. Turn on the server.Note: Approximately 1 to 3 minutes after the server is connected to ac power,the power-control button becomes active.2. When the prompt is displayed, press F1. If you have set anadministrator password, you are prompted to type the password.3. Select System Settings → Adapters and UEFI drivers.4. Select Please refresh this page on the first visit and press Enter.5. Select LSI controller_driver_name Driver and press Enter, wherecontroller_driver_name is the name of the SAS/SATA controller driver. For theSAS/SATA controller driver name, see the documentation that comes with yourcontroller.6. To perform storage-management tasks, follow the procedures in thedocumentation that comes with the SAS/SATA controller.When you have finished changing settings, press Esc to exit from the program;select Save to save the settings that you have changed.82 System x3200 M3 Types 7327 and 7328: Installation and User’s Guide