v The electromagnetic interference (EMI) integrity and cooling of the server areprotected by having all bays and PCI and PCI Express slots covered oroccupied. When you install a drive, PCI, or PCI Express adapter, save the EMCshield and filler panel from the bay or PCI or PCI Express adapter slot cover inthe event that you later remove the device.v For a complete list of supported optional devices for the server, seehttp://www.ibm.com/servers/eserver/serverproven/compat/us/.Installing a DVD driveTo install a DVD drive, complete the following steps:1. Read the safety information that begins on page vii and “Installation guidelines”on page 29.2. Turn off the server and peripheral devices, and disconnect the power cordsand all external cables.3. Unlock the side cover.4. Remove the side cover (see “Removing the side cover” on page 32).5. Remove the two-piece bezel (see “Removing the two-piece bezel” on page32).6. Use a screwdriver to pry the filler panel and EMC shield away from the server.Note: If you are installing a drive that contains a laser, observe the followingsafety precaution.Statement 3:CAUTION:When laser products (such as CD-ROMs, DVD drives, fiber optic devices,or transmitters) are installed, note the following:v Do not remove the covers. Removing the covers of the laser productcould result in exposure to hazardous laser radiation. There are noserviceable parts inside the device.v Use of controls or adjustments or performance of procedures otherthan those specified herein might result in hazardous radiationexposure.Chapter 2. Installing optional devices 41
