IBM 7328C1U Installation And User Manual

Also see for System x3200 M3: Brochure & specs Product guide Product guide Service guide Product guide

Contents

The blue-screen capture feature captures the video display contents before the IMMrestarts the server when the IMM detects an operating-system hang condition. Asystem administrator can use the blue-screen capture to assist in determining thecause of the hang condition.Enabling the remote presence featureTo enable the remote presence feature, complete the following steps:1. Install the virtual media key into the dedicated slot on the system board (see“System-board optional-device connectors” on page 25).2. Turn on the server.Note: Approximately 1 to 3 minutes after the server is connected to ac power,the power-control button becomes active.Obtaining the IP address for the IMMTo access the Web interface, you need the IP address for the IMM. You can obtainthe IMM IP address through the Setup utility. The server comes with a default IPaddress for the IMM of 192.168.70.125. To locate the IP address, complete thefollowing steps:1. Turn on the server.Note: Approximately 1 to 3 minutes after the server is connected to ac power,the power-control button becomes active.2. When the prompt Setup is displayed, press F1. (This prompt is displayedon the screen for only a few seconds. You must press F1 quickly.) If you haveset both a power-on password and an administrator password, you must typethe administrator password to access the full Setup utility menu.3. From the Setup utility main menu, select System Settings.4. On the next screen, select Integrated Management Module.5. On the next screen, select Network Configuration.6. Find the IP address and write it down.7. Exit from the Setup utility.Logging on to the Web interfaceTo log on to the Web interface to use the remote presence functions, complete thefollowing steps:1. Open a Web browser on a computer that connects to the server and in theaddress or URL field, type the IP address or host name of the IMM to whichyou want to connect.Note: The IMM defaults to DHCP. If a DHCP host is not available, the IMMassigns a static IP address of 192.168.70.125.2. On the Login page, type the user name and password. If you are using the IMMfor the first time, you can obtain the user name and password from your systemadministrator. All login attempts are documented in the event log.Note: The IMM is set initially with a user name of USERID and password ofPASSW0RD (passw0rd with a zero, not a the letter O). You have read/writeaccess. You must change the default password the first time you log on.Chapter 3. Configuring the server 79