Important: If the system-error LED on the front of the server is lit but there areno other error indications, clear the system-event log and shutdown the server.Also, after you complete a repair or correct an error, clear the system-event logto turn off the system-error LED on the front of the server.– POST Event ViewerSelect this choice to enter the POST event viewer to view the error messagesin the POST event log.– System Event LogSelect this choice to view the error messages in the system-event log.– Clear System Event LogSelect this choice to clear the system-event log.v User SecuritySelect this choice to set, change, or clear passwords. See “Passwords” on page114 for more information.This choice is on the full and limited Setup utility menu.– Set Power-on PasswordSelect this choice to set or change a power-on password. For moreinformation, see “Power-on password” on page 114.– Clear Power-on PasswordSelect this choice to clear a power-on password. For more information, see“Power-on password” on page 114.– Set Administrator PasswordSelect this choice to set or change an administrator password. Anadministrator password is intended to be used by a system administrator; itlimits access to the full Setup utility menu. If an administrator password is set,the full Setup utility menu is available only if you type the administratorpassword at the password prompt. For more information, see “Administratorpassword” on page 115.Attention: If you set an administrator password and then forget it, there isno way to change, override, or remove it. You must replace the system board.– Clear Administrator PasswordSelect this choice to clear an administrator password. For more information,see “Administrator password” on page 115.112 IBM System x3500 M3 Type 7380: Installation and User’s Guide
